Daily Fasteners and Fixings News by Bazibaza

Youtube

Adjustable Torque Screwdriver Prevents a Fastener From Being Under and Over Tightened – YouTube

 http://www.mountztorque.com/products/torque-wrenches/tbih?kmas=216 The Ergo Micro Torque Screwdriver is an externally adjustable tool that offers different setting options for applications that require more than one torque value. The adjustable ... [Read More]
2013/01/10

Norma Group – Andreas Trösch über sein Unternehmen | YouTube

 Andreas Trösch, Director Investor Relations der Norma Group, auf dem Equity Forum der German Graduate School of Management and Law über Erfolge und Entwicklung seines Unternehmens. (...) via Norma Group - Andreas Trösch über sein Unternehmen - ... [Read More]
2012/07/13

Wind Turbine Fastener Fundamentals | YouTube

 Basic information on fasteners used in wind turbines. Visit www.windtechtv.org for more video. Produced by Highland Community College as part of WindTechTV.org, a project supported by the National Science Foundation as part of the Advanced Technol... [Read More]
2012/06/04

Cold Forming vs Screw Machining Speeds | YouTube

 Cold Forming vs Screw Machining Speeds (...) via Cold Forming vs Screw Machining Speeds - YouTube. [Read More]
2012/05/10

Nordson® Unity™ Systems & 3M™ Plastic Bonding Adhesives – Mobile Electronics Assembly Solution | YouTube

 Nordson® Unity™ Systems & 3M™ Plastic Bonding Adhesives enable rapid assembly of mobile electronic devices that are stronger and smaller than those made with conventional fasteners or tapes. (...) via Nordson® Unity™ Systems & 3M™ ... [Read More]
2012/04/26

San Shing Bolt Measurement System DEMO – YouTube

 San Shing Bolt Measurement System- Resolution: 1600x1200 pixels Lens: Telecentric Lens (...) via San Shing Bolt Measurement System DEMO - YouTube. [Read More]
2012/03/03

FORGE simulation thread rolling.avi | YouTube

 The 2D/3D simulation tool for material forming FORGE (TRANSVALOR) shows the complete simulation of a thread rolling process. www.transvalor.com - marketing@transvalor.com (...) via FORGE_simulation_thread_rolling.avi - YouTube. [Read More]
2012/01/08